Aspect BIS VISTA Spécifications télécharger pdf (Page 35)

SECTION 4 PREPARATION FOR USE AND INSTALLATION

_______________________________________________________________________

4-3

4.1.4.1 Mounting the Monitor using the Pole Clamp

To mount the monitor to a secure vertical pole (1/2" - 1½" in diameter):

1. Place pole within clamp bracket and tighten screw using the black finger knob. Make

sure that there is enough space above the clamp so that you have a few inches to slide

the monitor in from above.

2. Line up the clamp shoe (on back of monitor) with the slot on pole clamp and slide

monitor down to fit. The bottom of the clamp shoe should be seen well below the

bottom of the pole clamp, and the monitor should snap securely into place.

Figure 7 - Pole Clamp

To remove the monitor, press tab on top of clamp shoe before sliding monitor up.

The pole clamp may be locked onto the monitor so that the two do not get separated. To do

this:

1. Line up the clamp shoe (on back of monitor) with the slot on pole clamp and slide

monitor down to fit. The bottom of the clamp shoe should be seen well below the

bottom of the pole clamp and the monitor should snap securely into place.

2. Make sure that set screw hole on pole clamp aligns with corresponding hole on clamp

shoe.

3. Remove black knob screw from pole clamp.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 93 94

Pas de commentaire

Aspect BIS VISTA Spécifications Page 35